What size are you planning to order? The real question is can each person order a different size or do they all have to be the same?
Gene
Gene
GROUP PURCHASE OF KICKA$$ RADIATORS
Trying to get a group purchase together for some AWESOME, SUPER COOL radiators for the FFR Cobra. These are top quality, high performance radiators made by
Ron Davis Radiators , and being offered by Gordon Levy .
These radiators feature:
Better cooling than the stock donor unit (wider and thicker)
All aluminum construction
Dual 12" fans
Custom shroud
Per Gordon, the cost is as follows:
Here is an example of what they look like. They will have the correct Ford inlet/outlet, and can be ordered with or without a filler neck.
![]()
2FAST
[ October 02, 2002, 03:56 PM: Message edited by: 2FAST4U ]
Ron Davis Radiators , and being offered by Gordon Levy .
These radiators feature:
Better cooling than the stock donor unit (wider and thicker)
All aluminum construction
Dual 12" fans
Custom shroud
Per Gordon, the cost is as follows:
We have three orders so far. If you are interested, please call Gordon Levy, and post here.
Here is an example of what they look like. They will have the correct Ford inlet/outlet, and can be ordered with or without a filler neck.
2FAST
[ October 02, 2002, 03:56 PM: Message edited by: 2FAST4U ]
- Status
1 - 4 of 54 Posts
You guys that are worried about too much shrouding should check this fan out. This is what I am going with.
These fans have their own shrouding and if you look closely, you can see 'rubber flaps' along the top and bottom of the shroud. The flaps open from forced air during cruise and close from fan suction when idling. It's made by Spal and puts out 2780 cfm. Runs about $280 plus another $50 or so for the thermostat/relay kit.
![]()
Spal-USA
Gene
These fans have their own shrouding and if you look closely, you can see 'rubber flaps' along the top and bottom of the shroud. The flaps open from forced air during cruise and close from fan suction when idling. It's made by Spal and puts out 2780 cfm. Runs about $280 plus another $50 or so for the thermostat/relay kit.
Spal-USA
Gene
I mentioned in my previous post above that I was going to use the dual Spal fans. Well, I ended up purchasing the 'off the shelf' Ron Davis radiator (just happened to be the size I wanted) from Gordon and installed it over the weekend. So far this setup is working great! Fans kick on at 195 and within 1 minute the temp is back down to 180 and fans shut off. The real test of course, will be when I get stuck in traffic during the summer but all indications point to no problems.
Here's a pic of my new setup.
![]()
Gene
Here's a pic of my new setup.
Gene
1 - 4 of 54 Posts
- Status
