Factory Five Racing Forum banner

Front upper control arm Q...

321 Views 2 Replies 3 Participants Last post by  grumpy
I was going over the car today checking torgue on bolts before the run to the DV. I noticed the nuts on the ends of the front upper control arms (these are the nuts that the grease fittings are screwed into) are not very tight. How tight should they be?

1 - 1 of 3 Posts
1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.