Factory Five Racing Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
89 Posts
Discussion Starter · #1 ·
Hi all,

I was taking my friend's Cobra to storage last night and apparently he didn't notice his wind wing about to fall off the brackets. It was being held on my just two screws and a washer. These are stock Factory Five wind wings and is the hardware that actually attaches the plexi to the brackets.

I could really use: Two screws
Three Washers
Four Acorn Nuts

or a source for them. Thanks in advance!

Marty
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top