Factory Five Racing Forum banner
1 - 4 of 4 Posts

·
Benched
Joined
·
3,181 Posts
Discussion Starter · #1 ·
For those of you who have your cables run under the frame I might have some help for you.

I have a couple of wear rings from my SeaDoo's that I think will work as a surface for the cables to ride on.

These are 3" wide and about 6 1/2" in diameter. The material is about 3/16" thick.

I think I can get about 5 out of each one so I will have 10 total. If you are interested just paypal me a buck or two for shipping and they are yours. First 10 people who PM me.

 

·
Premium Member
Joined
·
1,909 Posts
I actually used a sheet of 3/16" thick teflon I had left over from another project.
 

·
Senior Charter Member
Joined
·
1,623 Posts
Not to hijack your thread but if I had it to do over (and I may), I would not run my e-brake lines under the frame. I've scuffed speed bumps a couple of times and my cables are showing some minor damage, not enough to replace them but still it's not a good thing.

Tom
 
1 - 4 of 4 Posts
Top