Factory Five Racing Forum banner
1 - 1 of 1 Posts

·
Junior Charter Member
Joined
·
24 Posts
Discussion Starter · #1 ·
I slit the front upper ball joint dust boot (supplied by FFR) during the install.

I then purchased Energy Suspension part #5.13102.G (package of upper & lower ball joint dust boots) as a replacement. After installing the dust boot (#13024) from the Energy kit and running the upper & lower control arms through their full range of motion, I noticed that the dust boot gapped at the upper & lower limits of travel.

Can anyone tell me where I went wrong? I have read a few other posts where users have found the fit from the #5.13102.G kit perfect.

Thank you in advance for your help.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top