Factory Five Racing Forum banner
1 - 3 of 3 Posts

·
Senior Charter Member
Joined
·
887 Posts
Discussion Starter · #1 ·
I took the driveshaft over to be cut down to the 10.5 inch length as per the drawing in the manual. Is That correct length? I have the stock rear end from the 1990 mustang and the T-5 transmission. It just looks too short.
 

·
Senior Charter Member
Joined
·
887 Posts
Discussion Starter · #3 ·
Mike Thank you for the reply.
I will have to look at the drawing again and the shaft. I took the shaft and the drawing from the build manual to the shop and they did the cutting. They did a nice job. I have the 5.0 motor and the stock rear end. I just thought that the 10.5 inch driveshaft might bind if the rear axle moves alot.
 

·
Senior Charter Member
Joined
·
887 Posts
Discussion Starter · #5 ·
OK Thank you. It should be right then. Just looks small. Mike
 
1 - 3 of 3 Posts
Top