Factory Five Racing Forum banner

Deletion of emissions question?

309 views 3 replies 3 participants last post by  Doug Huey 
#1 ·
I am removing the TAB & TAD systems and the plug that goes to the air pump. I have read that you can just put a 10k ohm resistor in their place for each circuit. Being that the computer is expecting a much higher reading than 10k ohms resistance does it affect the way the engine runs?
Thanks,
RacerX

[ April 03, 2002, 11:26 AM: Message edited by: racerx ]
 
#4 ·
I did it to mine. The computer does not know the difference. No codes!

[ April 03, 2002, 12:58 PM: Message edited by: Kartman ]
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top