Factory Five Racing Forum banner
1 - 5 of 5 Posts

· Pro FFR Builder and Moderator
Joined
·
14,844 Posts
190-195 is fine, that's not hot.
 

· Pro FFR Builder and Moderator
Joined
·
14,844 Posts
What you have is a sensor problem. Tell me everything you can about your engine setup and wiring.
 

· Pro FFR Builder and Moderator
Joined
·
14,844 Posts
The computer sensors, not the gauges sensors, for air temp and water temp. Where they new?
 

· Pro FFR Builder and Moderator
Joined
·
14,844 Posts
There is a water temp sensor on the factory heater rail. It is required. There are ports in the intake you can use for this. The Air temp sensor is on the lower intake in the drivers side on the second intake tube near the bottom.
Both of these are required for the EFI to work correctly.
 

· Pro FFR Builder and Moderator
Joined
·
14,844 Posts
Ezra, give me a call. You can set up the water temp sensor without put the heater rail back in. In your diagram it's 17 and 18 I have been talking about.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top