Factory Five Racing Forum banner

1 - 7 of 7 Posts

·
OT Moderator
Joined
·
13,931 Posts
Discussion Starter #1
I can't find my coil over adjusting tool to adjust my ride height. I don't think FFR sent me one.

Anyone remeber where it is usually packaged? I've been through everything and can't seem to find it.

Think I could pick up one locally? I don't feel like waiting weeks for FFR to send me one.
 

·
Senior Member
Joined
·
806 Posts
Rob,

I too did not receive one with my Mark III. I'm not sure if we were supposed to get one or not.

Mike
 

·
Moderator Ad Nauseum
Joined
·
18,585 Posts

·
just another builder
Joined
·
8,238 Posts
i got one...late mk2
it was in with the hardware,,,i think
 

·
OT Moderator
Joined
·
13,931 Posts
Discussion Starter #6
Yes I do Don, thanks.

I thought we got these, but I guess not.

Thanks Guys.

My spreadsheet sure is a growing.
 

·
Senior Charter Member
Joined
·
2,501 Posts
Rob,
If you haven't tightened the set screw yet, you can just turn the nut by hand. I bought a spaner and only used it to turn the nut after locking the set screws. The set screw will put a ding in the threads and It's hard to turn them until you clean the threads up. A few turns does it. For now I have left them loose until I'm finished tweaking. I just lift the car and turn the nut by hand now. I wish I new this sooner, I would not have tightnened them so soon. When I do tighten them, I won't crank them down like last time.
 
1 - 7 of 7 Posts
Top