Factory Five Racing Forum banner
1 - 10 of 10 Posts

·
Premium Member
Joined
·
2,513 Posts
Discussion Starter · #1 ·
I used the "All Things Cobra" site for the badge measurements...
http://allthingscobra.tripod.com/exterior.html

...but the one on the nose seems to far forward. In only used tape so I can move them.

Did anyone else think this 10 3/4" is too far forward?

Thanks.
 

·
Charter Member
Joined
·
2,035 Posts
John,
I am happy with the placement of mine. Mine measure about 10 3/4 to the pin on the badge that is closest to the front of the car not the rearward pin as shown in the diagram. HTH.

P.S. - Cool site. I haven't seen that one before. Thx
 

·
Senior Member
Joined
·
1,595 Posts
Try FFR FAQ, the measurements are there under medallions.

Bill G
 

·
Registered
Joined
·
9,942 Posts
That site ripped off the diagrams from ERA. They are correct.
 

·
Still broke & dreaming...
Joined
·
2,205 Posts
They even used a pic of Dave Smith's FFR on their "Authentic Touches" page. LOL!

EDIT: removed lame Tripod linked image...

[ July 11, 2007, 02:05 PM: Message edited by: TBirdNutt ]
 

·
Junior Charter Member
Joined
·
1,795 Posts
I used this as a reference and mine look fine and seem to be the same as everyone elses. I cut the pegs off the emblems and used double sided emblem tape so they can be removed if needed:
 

·
Super Moderator
Joined
·
29,537 Posts
I see Chuck Robertson's Cobra in the Red Gallery section
 

·
Blue Oval Scribe
Joined
·
9,177 Posts
Ugh! I hate Tripod sites. Pay a few bucks for some hosting will ya!
 

·
Premium Member
Joined
·
2,513 Posts
Discussion Starter · #10 ·
I moved the nose badge to one badge width down from the centre. Like that look better. It should also give me room to try that little rock guard the Finishline has.

Thanks for the help!
 
1 - 10 of 10 Posts
Top