Factory Five Racing Forum banner
1 - 5 of 5 Posts

·
FFCobra Fanatic
Joined
·
724 Posts
Discussion Starter · #1 ·
A good friend of mine molds carbon fiber stuff as a hobby. We've talked several times about laying up a set of carbon fiber wheel wells/tubs for 2468.

Has anyone else done anything similar?

Is anyone interested in a set if can make them?

They're likely to be expensive....but my vision is a full tub that just bolts in......

Please let me know if you all have any thoughts or questions.

Thanks, Al
 

·
4.6 Terminator Trailblazer
Joined
·
1,743 Posts
I like the side vent idea a lot!!, a vendor of CF front spoiler would be nice too. I've seen motercyle wheels that are CF, and an NSX with CF wheels from Japan, it looked good.
 

·
Senior Charter Member
Joined
·
1,056 Posts
Seems like swatting a fly with a sledge hammer.

sure carbon fibre is cool, but why?

By the way, I've never had wheel wells and have never needed them.

The stick junk from the track comes off, and other than a bit of noise road gravel has no effect on my paint.

Just my two cents.
 

·
Junior Charter Member
Joined
·
882 Posts
Id like to see a new, slightly larger hood scoop.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top