Factory Five Racing Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter #1
I have read a few posts but just want to ensure I am going in the right direction. I have removed the passenger side roll bar and will need to fill the 3 holes in an unfinished Mark 3 body. From what I have read;

1. I should use a mesh from underneath to form a platform or base.
2. feather out the holes from the top to get rid of the sharp edges
3. Use a product like Everglass short strand body filer to fill the 1/8 deep hole
4. Finish the top layer with Rage Gold

Does it matter what type of mesh or resin I use on the underneath side of the body?

Thanks for any advice.
 
1 - 1 of 1 Posts
Top