Put mine on the buck yesterday too after picking up on Saturday. I concur that the front is great but the rear is poor. Theres about a 1" gap at the top of the wheel arches. On the other hand I'm touching in the middle and at one place on each side so I believe that there should be no distortion even after many months. Does that sound correct?
Body Buck from FAQ jpg
I printed the JPEG versions of the body buck templates found in the FAQ on a plotter. I am cutting them out and just figured I would sanity check my printout. The measurements on my printouts seem to be quite different from the measured drawings I have found.
Has anyone used these images and do they fit the body well? Is there a straight line dimension that I could check to be sure my printout did not scale in some strange way?
Thanks,
- Jesse
Has anyone used these images and do they fit the body well? Is there a straight line dimension that I could check to be sure my printout did not scale in some strange way?
Thanks,
- Jesse
1 - 1 of 8 Posts
1 - 1 of 8 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Factory Five Racing Forum
A forum community dedicated to Factory Five owners and enthusiasts. Come join the discussion about performance, racing, conversions, modifications, troubleshooting and drivetrain. We discuss MK4, GTM, 818, Type 65 coupe, roadsters, and more!
Full Forum Listing
Recommended Communities
