That's plenty of support. At FFR I saw several bodies supported in the wheel wells on 2x4s on end. You won't hurt the body. The pipe insulation trick is good too.
TEC
TEC
Body Buck from FAQ jpg
I printed the JPEG versions of the body buck templates found in the FAQ on a plotter. I am cutting them out and just figured I would sanity check my printout. The measurements on my printouts seem to be quite different from the measured drawings I have found.
Has anyone used these images and do they fit the body well? Is there a straight line dimension that I could check to be sure my printout did not scale in some strange way?
Thanks,
- Jesse
Has anyone used these images and do they fit the body well? Is there a straight line dimension that I could check to be sure my printout did not scale in some strange way?
Thanks,
- Jesse
1 - 1 of 8 Posts
1 - 1 of 8 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Factory Five Racing Forum
A forum community dedicated to Factory Five owners and enthusiasts. Come join the discussion about performance, racing, conversions, modifications, troubleshooting and drivetrain. We discuss MK4, GTM, 818, Type 65 coupe, roadsters, and more!
Full Forum Listing
Recommended Communities
