Factory Five Racing Forum banner
1 - 2 of 2 Posts

· Registered
Joined
·
4,738 Posts
Discussion Starter · #1 ·
I tried installing the brake hose that came with my CNC reservoirs onto the npt fittings. I can get them on about 3/4 ways and that's it. I tried heating the hose in hot water, but didn't notice a difference. My thumb and fingers were sore from fighting just one hose and it's not fully seated.
Can I apply any chemicals to make it slide better? (brake fluid? soapy water?)

suggestions?
 

· Registered
Joined
·
4,738 Posts
Discussion Starter · #5 ·
I'll try the brake fluid first, if that doesn't work I'll try the Sil-Glyde.

Thanks!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top