Factory Five Racing Forum banner
1 - 3 of 3 Posts

·
FFCobra Master Craftsman
Joined
·
1,941 Posts
Discussion Starter · #1 ·
Well, I'll soon have the F panels and firewall done. I'm waiting for the control arms to come back from the powder coaters. What else can I do with no suspension? Can I mount the drivers and passnegers floor panels, or will they block my wiring, fuel, and brake line installation? Thanks in advance!

Ed Reynolds
 

·
Registered
Joined
·
401 Posts
You COULD do MOST of the sheetmetal without doing any riveting (What?) Do your placement and drilling with panels held in with clecos. Then if you need to do other work with the sheetmetal off, no problem. Personally, I did both the fuel lines and brake lines after the floor panels and footboxes were installed with no problems.

Good luck!

Len
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top