Factory Five Racing Forum banner
1 - 3 of 3 Posts

· Junior Charter Member
Joined
·
325 Posts
Another Combination

I am using a Holley carb with a Weiand Stealth manifold and a ford racing 8x11x2.5" oval air cleaner. It fits fine and takes advantage of the scoop. The stealth is a mild high rise intake.
 

Attachments

· Junior Charter Member
Joined
·
325 Posts
Frank, I am using one on a 351w

Frank I must be missing something. I am using the current setup shown in the picture on my 351W. Is there some reason I should remove it?
 

· Junior Charter Member
Joined
·
325 Posts
Thanks for pointing that out

Hi Frank: I am just finishing up this 351 install and forgot about updating my profile. I wasn't sure it was going to work, maybe I just lucked out using the Weiand Stealth intake. I used some clay on the back side top of the air cleaner and had about 3/4 of an inch to the hood underside and 3/4 to the brace molded into the hood liner. I am using the poly motor mounts.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top