Factory Five Racing Forum banner
1 - 11 of 11 Posts

·
FFCobra Fanatic
Joined
·
3,884 Posts
Discussion Starter · #1 ·
How would you install those grommets? I was thinking of putting them in the freezer? Thanks fellas!
 

·
Senior Member
Joined
·
2,372 Posts
Dishwashing liquid and a blunt screwdriver worked for me. Be careful of your fingers!
 

·
FFCobra Fanatic
Joined
·
1,345 Posts
I didn't even mess with mine, I took a 3/4" end mill and milled out the backside to a uniform 1/8 thickness. They were still a little tough to get in place but they fit nicely.
 

·
Senior Member
Joined
·
1,073 Posts
I don't want to discourage you from trying, but two of us sat at the kitchen table for hours and tried all of the ideas above. After a few beers we decided they looked great without the grommets!
 

·
Banned
Joined
·
907 Posts
I read this thread last week, and then took dish detergent,as recommended, a small regular screw drive (and heres the big tip!!!!) NO alcohol. I had all 4 in and (no blood) within 30 minutes. Then, and only then
May not sound very fun, and may not even be an option you'd consider. But it worked for me.
 

·
FFCobra Fanatic
Joined
·
3,884 Posts
Discussion Starter · #10 ·
Got them in, thanks guys. look good from the front, but the back, uhhhhh lets not!
 
1 - 11 of 11 Posts
Top