Factory Five Racing Forum banner
1 - 2 of 2 Posts

·
Vendor
Joined
·
8,399 Posts
Discussion Starter · #1 ·
I went out and finished wiring up my good friends FFR with a 408, Victor Jr heads, .620 lift mechanical roller cam, Victor Jr intake modified for EFI, Electromotive engine management system, 4 into 4's and it sounds nasty.
Look here

[ May 05, 2002, 01:55 AM: Message edited by: Wayne Presley ]
 

·
Vendor
Joined
·
8,399 Posts
Discussion Starter · #4 ·
Andy, the cam is a custom grind with 108 degree LC, int 245/.616, ext 253/.640 @.050 . THe CR is 10.5:1 Can you plug the numbers in your dyno programs?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top