Factory Five Racing Forum banner

1 - 4 of 4 Posts

·
Junior Charter Member
Joined
·
102 Posts
Discussion Starter #1
I am building a 351W for Cobra #2 and have a question. I am using GTP cast iron heads with an F cam and 1.7 Crane Roller rockers. My question is does anyone have a similar setup or know what the correct length pushrods are? The stock ones are too short to set up the proper preload. This is a roller cam in a 97 351W roller block out of a 97 F250. A
ny help would be much appreciated.

Thanks
Walt
 

·
Junior Charter Member
Joined
·
102 Posts
Discussion Starter #3
Thanks for the help. I am off to the shop to make the adj. push rod now!!

Walt
 

·
Rapscallion
Joined
·
1,969 Posts
Make sure you heat up the pushrod before you tap it. Just use one of those propane torches. Softens up the metal so you can work it better.

Roscoe
 
1 - 4 of 4 Posts
Top