[Tim Cronin]

After reading the instructions and looking at available pictures I'm not sure where the limiting straps attach on the axle end when using the rear coil overs and 3- link. Any one have pictures/details
Thanks
TEC

 

[Bill]

The instructions don't say to use them. I didn't but found the the drivers side could drop when being lifted so I went the "Help" section and bought a longer one and installed it in the same spot as the old one.

 

[Tim Cronin]

Thanks Bill
I don't have them handy but I thought the Coil over instructions mentioned attachong them to some oval hole I couldn't locate
TEC

 

[Grembler2]

Tim, If you look at the posts farther down, there is one about "3links and 295 not a good......" there are afew pics there. I hope it helps.

Eric

[ October 10, 2002, 04:42 PM: Message edited by: Eric the Red ]

 

[jacktunnell]

I've got a great picture of this. Send me your e-mail and I'll send it to you. It's a small file and will go over dial up OK if that is what you have.

[email protected]

 

[jacktunnell]

check the picture at this link.

http://photos.groups.yahoo.com/group/ffrspecracing/vwp?.dir=/&.src=gr&.dnm=Left+rear+chassis+with+3-link.jpg&.view=t&.done=http%3a//photos.groups.yahoo.com/group/ffrspecracin g/lst% 3f%26.dir=/%26.src=gr%26.view=t

You must copy & paste the whole link.

[ October 11, 2002, 08:54 AM: Message edited by: Jack T. ]

 

[Tim Cronin]

Thanks
I'm not having too much luck copying and pasting. Jack, you've got mail
TEC