Factory Five Racing Forum banner
1 - 12 of 12 Posts

·
Registered
Joined
·
335 Posts
Discussion Starter · #1 ·
Just double checking. The driver lower shock spring hat hits the 3 link bracket. I was just going to flip the shocks body down. I know it s a little more unsprung weight.
Any issues with doing that ?

Joe

MK4, Koni's
 

·
Registered
Joined
·
335 Posts
Discussion Starter · #4 ·
Heres a pict.. It would be easier to trim the 3/4 on an angle. As i have the shocks all mounted and marked.
Picts are at full droop.

Joe
 

Attachments

·
2010 FFCars Graduate
Joined
·
3,027 Posts

·
Snake Farmer
Joined
·
10,396 Posts
Flipped and trimmed..just to be on the safe side..lol
 

·
Premium Member
Joined
·
1,066 Posts
Assume the rear end is centered to the frame, mine was out a 1/4".
 

·
Registered
Joined
·
335 Posts
Discussion Starter · #12 ·
Thanks for the reply's. Its rough centered to about a 1/16.
Think ill just trim it a bit .

Joe
 
1 - 12 of 12 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top