Factory Five Racing Forum banner
1 - 3 of 3 Posts

·
Charter Member
Joined
·
832 Posts
Discussion Starter · #1 ·
Has anyone used the 15-inch Cobra calipers instead of the 17-inch so as to enable the use of 15" rims without using spacers?

I see them advertised by Discbrakesareus but they are a bit pricey!

Jerry
 

·
section 8
Joined
·
5,136 Posts
Jerry read the fine print , the 15" cobra calipers have cobra powder coated onto the housing . They are the however 2 piston PBR calipers meant for use with the smaller 11" rotor. If you price the 99+ up GT calipers from the Zone or Napa and add in the core and allow for powder coating the Cobra letters on the calipers . I think the DBRUS parts are competetive Bob
 

·
Building
Joined
·
833 Posts
Call Mike @ Forte's a vendor on this forum. He has real Ford Cobra 13" Setup Fronts & rear Calipers instock! $215/Set from what I recall - judt ordered rears from him couple days ago. PM me if your after some tips & keep the $$$ down.

Ron
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top