Factory Five Racing Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Parts For Sale / Wanted
    SOLD ~ SOLD ~SOLD $1500 USED ~ TKO 500 w/mid shift,drive-shaft, sbf steel bell-housing, clutch, pressure plate, shift fork. I don't need this anymore because I sold my 408 550 hp/550tq race motor and put in a stock 302 5 spd in my FFR Cobra to sell, nothing wrong with them except they're not...
  2. Parts For Sale / Wanted
    This came out of a Steeda mustang with very low mile. It comes with the bell housing but no shifter. You would need a different one anyways if you plan on using the central shift point. Local pick up only in Spring Hill, FL. (Central Florida)
  3. Factory Five Roadsters
    I'm using an older TKO, with the stock Tremec shifter. Great trans. A little big and heavy, but holds up to abuse really well. The shifting is a little notchy. But nothing unbearable. I think it's better than my stock '08 Mustang - which I find to be a little vague and rubbery...
  4. Factory Five Roadsters
    Promised to post some pics of Mike Fortes "Push" Hydraulic Slave setup for the TKO after I figured out how to mount it without replacing the Clutch Fork. I had just pulled the engine and tranny to replace a defective clutch disc and wanted to avoid pulling it again. The Fork supplied with the...
  5. Tire & Wheel Forum
    I have a set of wheels that look to be halibrand, but there are no markings any where on the wheels. The problem is that they seem to be porous enough that they keep losing air thru the wheel. Before I had the new tires mounted on them I painted the inside of the wheels with glyptal paint but 3...
1-5 of 5 Results
Top