Bear-AvHISTORY asked that I document how I added a shift light to my dash. So here it is.
I recently added a shift light to my roadster. It would have been easier to do this while building the dash. But, I thought of this after a few driving seasons because I’m a little paranoid of over...
Just checking to make sure I understand this.
Plug in the pigtail and hold down the button. The needle will move between full and empty. Push button to set point. Guage goes back to normal operation. Repeat steps to set the other point.
Ok been there done that trying to set empty with 3...
Do the new electronic gauges use an led to backlight the gauge and needle. I have the headlight switch and the rheostat on the switch does not dim the guages. Read that you cannot dim the leds, could that be my problem or something else?