Factory Five Racing Forum banner
hose
1-3 of 3 Results
  1. Factory Five Roadsters
    Good Morning, I installed my radiator this past weekend. After I installed it my brother in law mentioned he thought I would have a problem. Since I am using a Ford motor my hose comes straight up then needs to curve at a 45 off the motor to head towards the actual radiator. He stated...
  2. Factory Five GTM Forum
    I pulled out the metal corrugated hoses that FFR supplies to connect the water pump to the coolant tubes that pass through the tunnel. I found replacements that I believe will be a better overall solution. These are Gates Vulco Flex II hoses. About $40 for both hoses. I still need to install...
  3. Factory Five Roadsters
    Whitby cube heater There is some conflicting info when I did a search about routing the hoses. The outlet to the heater (HOT) goes from top of the manifold near the thermostat housing to the highest inlet on the cube heater. ( Also the hose where the cutoff should be installed if desired)...
1-3 of 3 Results
Top