I've been researching the heck out of these parts, and need a check...
Here's the Fuel System recommendations in the Gen 3 Coyote Install Instructions (Download)
Summit Racing - Fuel System
AEI-13129 – 6AN Fuel pressure regulator
SUM-220166B – 6AN O-ring to straight 6AN Adapter (2 needed)...
Hi,
I'm not much of a blogger but I have a question on fuel tank and pump choices.
my son helped me set my ffr standard tank in place last night. I installed the pick up unit and the sender unit, vent and stuff... I noticed the return line had a rubber plug on the inside portion of the pipe...
All items listed below are very lightly used. All in great working condition. Anywhere between 500 and 1,500 miles. I have since upgraded my engine, fuel systems to run E-85 as well as eliminated the controls pack PCM in favor of an aftermarket ECU thus eliminating the need for the parts listed...
Hello,
I wanted to get some opinions of fuel system options. I purchased a fuel kit from a vendor and wanted to see if I could get some advice. The kit I purchased uses Socketless barb with AN fittings. (See picture attached). The hose the vendor gave me is 350 PSI and is rated to carry fuel...
Just wondering if there's anyone out there that's been able to make C6 gas tanks work. Looks like the donor parts kit I have came with a set of C6 tanks and I'm struggling to find other builders that have used them.
If there's anyone out there that didn't abandon C6 tanks in favor of aluminum...
Hello
I have been trying to figure out this problem for months. I cant seem to get the GTM to start.
When I try to start the engine, it fires and dies. I took the fuel injectors out and tried starting it and the would pulse twice and then stop. I have spark and my fuel rail pressure is...
Just checking to make sure I understand this.
Plug in the pigtail and hold down the button. The needle will move between full and empty. Push button to set point. Guage goes back to normal operation. Repeat steps to set the other point.
Ok been there done that trying to set empty with 3...
Hey Guys, I'm back....
After building my FFR roadster several years ago, I ventured out to the FI world with my Ultima GTR. Now I've bought a 1968 Camaro and am rebuilding it which gets me to my question.
Can someone please provide a scan of the FFR manual on wiring the fuel pump with a carb...
I've been reading and gaining knowledge on the stock tank crossover fitting and potential leakage. I came across a post where a member was planning not to install the crossover fitting and add a system to allow drawing fuel from one tank at a time. I also notice the way the system is set up in...
Both lighty used (500 miles)
250 degree oil temp SOLD SOLD SOLD SOLD
http://www.summitracing.com/parts/ATM-4347/
I replaced it with a 300 degree unit. Comes in box that replacement arrived in with all bits
$35 shipped to US. Pay pal only
Fuel gauge SOLD SOLD SOLD SOLD to...
I have a new TWM Stack Fuel Injection System for a FE Ford for sale or trade. you will still need a fuel management system to run it, but it is the pretty part. I am willing to trade this for a stack system for a 351W if it is in like condition. I ended up not using this, but I am in need now...
Is there any reason for me to try to find a particular type of braided fuel filler ground strap or can I just use some 10 ga wire with a couple of crimped on ends? With the exception of flexibility, is there really a difference?