mjpesky mjpesky is offline
- About mjpesky
- Location (City / State)
- new jersey
- union electrician
- Factory Five Kit Type
- Roadster - Mark I
- FFR Number
- Car Color (paint code)
- undecided (black/silver)
- 408, victor jr heads and intake
- Engine Induction
- Fitech EFI
- Tremek TR3550
- Rear End
- 8.8 4 link with panhard
- Coil overs
- Forgestar F14. 18x11 18x9
- Pilot Super Sports 290 &245
- Cobra R M2300K
- Livernois Motorsport 408 stroker. Victor jr. intake, stage 2 ported heads. Tremek TKOII.
- Start Build Date
- Build Finish Date
- Car Picture
- Other Vehicles
- 2015 F150 3.5 eco
2011 Mustang GT
2014 Kia Soul
- 16yr project MK1. Purchased 5/2001. 600hp 408 Stroker. Stage2 ported Victr Jr heads/intake. Flaming River rack, Cobra R brakes, TKO2 tranny, Meziere electric water pump, custom dropped trunk w/ 20 gal. RCI fuel cell, energy suspension mounts, Autoweld upper control arms, panhard bar, Trutrac Detroit locker, 3.73 gears, Autometer Ultra-lite gauges, Fitech EFI-4 fuel injection, and the list goes on!!
|09:09 PM - matej quoted mjpesky in post Car was running great... Died.. Now cranks, starts, and dies immediately.
...anks--Mike Hi Mike (mjpesky). Did you end us ...
|08:26 PM - SJDave quoted mjpesky in post Thanks for the clarification
Dave the pinion gears are th...
|04:08 PM - johnnybgoode quoted mjpesky in post Best starter for a 408 with 10:1 compression?
Clunk and smoke from the old...
|02:20 AM - BS quoted mjpesky in post 408 stoker redline and rev limiter suggestions?
Vector.... confused. What ...
|11:21 PM - Bob Cowan quoted mjpesky in post 408 stoker redline and rev limiter suggestions?
Thanks guys. BTW it's a sol...
|03:00 PM - Bob Cowan quoted mjpesky in post 408 stoker redline and rev limiter suggestions?
app, 60mph puts me @ 7200rpm...
|03:01 AM - mcondos quoted mjpesky in post Did I screw up 18yrs ago with my flywheel selection?
Ok.. soooooo. After reading ...
|08:35 PM - edwardb quoted mjpesky in post Did I screw up 18yrs ago with my flywheel selection?
Well, I just talked to Liver...
|09:22 PM - BEAR-AvHISTORY quoted mjpesky in post Open, closed PCV or oil catch can?
Thanks guys. Dan, your inst...
|09:11 PM - rich grsc quoted mjpesky in post Aftermarket dofferential cover fluid capacity.
I have an aftermarket differ...
|03:51 PM - johnnybgoode quoted mjpesky in post Oil pressure too low?
Startup 45psi. Running at ab...
|02:39 AM - Buck8one2 quoted mjpesky in post What would you set idle at?
Thanks guys! Buck, I forg...
|03:53 AM - SJDave quoted mjpesky in post Just installed the Stant also
Thanks Mark. Would you recom...
|10:14 PM - Greg_M quoted mjpesky in post Vented radiator cap confusion.
Second 16# cap. A Stant cap....
|12:27 AM - AC Bill quoted mjpesky in post Coolant pressure question
My question is... with a 2...
|11:39 AM - Greg_M quoted mjpesky in post Coolant pressure question
22# vented cap...do you thin...
|02:06 AM - sejust2009 quoted mjpesky in post Thoughts from a newbie in London.
First off, let me say, I am ...
|12:22 PM - Chepsk8 quoted mjpesky in post Operating temp question.
Hey Dan... I just swapped o...
|03:06 PM - railroad quoted mjpesky in post Car was running great... Died.. Now cranks, starts, and dies immediately.
Didn't notice that. I think...
|06:01 AM - CRZN 427 quoted mjpesky in post Say Whaaa....
Bingo Am I seeing that th...
|iTrader Profile||Recent Ratings|