christenfreedman christenfreedman is offline
- About christenfreedman
- Location (City / State)
- Car Color (paint code)
- Silver Mink
- Engine Induction
- TKO 600
- Rear End
- Levy Narrowed 8.8 center w/9" ends
- 3 link, narrow width
- 15" PIN DRIVE
- Goodyear bil
- Build Web Site / Pictures
- Car Picture (2nd kit)
|05:55 PM - picah quoted christenfreedman in post My ‘reasonably authentic’ 427 S/C build log
I have the acton reproductions. They ...
|09:26 PM - christenfreedman quoted inthelead in post Finishline?
We all miss Enzo Most Defin...
|09:47 PM - christenfreedman quoted JKleiner in post Issue setting camber
I was about to say the same--...
|03:32 PM - JoeE quoted christenfreedman in post Issue setting camber
Yeah I finally cut mine this past wee...
|03:54 AM - christenfreedman quoted edwardb in post FinishLine Trunk Prop Rod Mockup
|03:39 AM - christenfreedman quoted robanno in post Issue setting camber
Thanks to all !!! Looks like...
|03:10 PM - initiator quoted christenfreedman in post Has anyone tried this "quick jack"...thoughts?
Keep in mind that the 5k version is s...
|01:16 PM - christenfreedman quoted initiator in post Has anyone tried this "quick jack"...thoughts?
Greatly appreciate this note a...
|05:54 PM - initiator quoted christenfreedman in post Has anyone tried this "quick jack"...thoughts?
I recently got the 5000lbs version an...
|02:48 AM - christenfreedman quoted Mike Forte in post Quick release windshield brackets
Hi Guys, Many have asked me ab...
|01:30 PM - christenfreedman quoted broark551 in post Oil puke tank
You have any pics of them inst...
|01:09 PM - christenfreedman quoted rmally in post Is this car Viking Blue?
Hey guys, Can someone te...
|08:51 PM - christenfreedman quoted cj in post Book?
I recently got the Cobr...
|06:11 PM - christenfreedman quoted MCathcart in post Anyone have pics with black roll bar and side pipes?
|10:17 PM - mkosch1 quoted christenfreedman in post Dash support tubes question
It will only take a few degrees to ma...
|12:38 PM - christenfreedman quoted mkosch1 in post Dash support tubes question
What angle did you set your ...
|12:18 PM - christenfreedman quoted M DOUGHERTY in post Lemans top
If they decide to do a lemans to...
|04:11 AM - christenfreedman quoted daltmcintyre in post Tank source
Where did you source the tank fro...
|01:15 PM - christenfreedman quoted CDXXVII in post Throttle Linkage Kit and Return Springs
Yes! The rod ends are instal...
|05:05 PM - 6t8dart quoted christenfreedman in post Back Wall Sheet Metal - Waviness in the top flange
It appear the the holes in the chassi...
|iTrader Profile||Recent Ratings|