Factory Five Racing Forum banner

Broken Water Temperature Sensor

354 views 2 replies 2 participants last post by  EZ$ 
#1 ·
Well, put me in with the group who've had the stem snap on the temperature sensor. I was trying to move the wire over to avoid heat sources, so I went to loosen the nut, and it came off with the threaded stud.
I had read how fragile these things were so I thought I had made sure to not overtighten, but it's kind of ridiculous how brittle they are. Speedhut really needs to revisit the design.
Sorry, just frustrated, and had to vent a little. Three steps forward, two steps back.
 
#2 ·
Gauge or EFI temp sender?
If it's EFI, it a 95 Camaro LT1 sender. If for the guage you will have to get that from the manufacturer.
 
#3 ·
Gordon, It's the gauge sender. Just frustrating. I'm finally at the point where I can start the FI wiring, and finish up the MSD wiring, and I run into this. Anyhow, I'll be in touch on Monday.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top