Which panel to use.

[ldsman]

The panel which goes where the steering and the power booster goes. I have both panels. With and with out the clutch quadrant. I have a 2005 + transmission with the 4.6 3 valve. Just need to know what panel to use. If anyone has pictures of this please post them. Im going manual brakes and manual steering.

[AZPete]

Robert, I can't picture which panel(s) . . . with clutch quadrant? Can you post a picture or give a more detailed description?

[rich grsc]

Have a manual?

[JKleiner]

When viewing it from the front the driver's footbox front bulkhead panel with the clutch cable cutout in the upper LH corner is for a donor pedal box, the panel with it in the upper RH corner is for Wilwood pedals.

Jeff

[AZPete]

Thanks, Jeff, now I understand. Hopefully Robert comes back to see this.
Pete

[d42davis]

As this is the mod motor section, I assumed the question was which panels were required to fit a mod into the engine bay. You should know that mod motors are quit wide with their overhead cams and require more space.
There are 3 panels that I had to change which were in the box of miscellaneous panel parts for my Mk 3.1. The front, inside and top driver footbox panels had to be replaced to make room for the wide mod motor. It's been a while, but I believe the new front panel fit both the donor and Wilwood pedal boxes.

[ldsman]

thanks guys. i found out i needed the panel not drilled yet. i have since install the right panel and tonight i have installed the engine the 4.6 3 valve