4 brackets for the seat track

[RF RIDER]

I am pretty sure it was David Borden who was selling the 4 brackets for the seat tracks. Does anyone know if he is still selling these or has someone else taken this over to sell.
Please point me in the right direction as I would like a set.

thanks for your time.

David

[motohead]

I too have been trying to contact Dave Borden for those seat brackets.
No response yet. They seem simple enough to make, but his were very clean and figured out.
If anyone finds another source please post it here.
Thanks, Tim Sharp

[Mjollnir]

Tim, I have a set of 4 of Davids brackets that I will not be using. I am making my own seat base.
You can have them for what I paid ($40) plus shipping. PM me.

[RF RIDER]

I was originally looking for these brackets, but no big deal, Tim can get those.
If I cannot source these, could someone post the dimensions of the bracket and I can make my own set.

thanks

[mendo]

I contacted David about those, he said that another person was starting to make them, he gave me his name but I forgot.
contact him again via PM and he will get back to you.

[Shane]

I've been making these out of 1/8" steel on the past several builds. I cut them here on the plasma table and bend them to 90 degrees. They are not nearly as "pretty" and elegant as the ones I've purchased from David, but they do the trick, and once they're installed, you can't see them anyway. I'm going to be out of the shop for the next couple weeks, but if there is a need for them, I'll get them posted on my website when I get back. I have not done this before because I didn't know if David still wanted to sell them or not.........

[RF RIDER]

Sounds good Shane. I was planning on making another order from you anyways. When you get back could you run me a set and in the meantime I will send you a PM next week to order some parts.

thanks

David