Simple Brake Question

[ACE]

What is being used in place of the brake pressure switch,I'm looking for an electrical brake switch that will mount in the same hole?

[Richard Oben]

Use the mustang switch it is not Pressure in the true sense of the word. Very reliable. Hope this helps. Cheers Richard.

[ACE]

Richard, I have the Painless wire harness,so is there a connector I need to get then?

Thanks [img]smile.gif[/img]

[John / My427SC]

Here is one way to do it, the switch goes into the hole that the cruise control dump switch used:

[aeickstaedt]

John thanks for the Auto Zone brake switch part no. I was wondering what to do about my brake lights also.

[mikiec]

Ace,

Just crimp connectors on the wires and hook it up.

Mike

[Richard Oben]

Even if you have the painles the mustang switch works great. Just put a spade connector on the orange and the white put one on each terminal on the Mustang switch and it works great. Cheers Richard.

[wnstwolf]

Just did what Richard stated last week. I have the painless set-up and you put the clips on the orange wire and White wire does not matter what side goes where..

tadaaa I have brake lights..

[ACE]

Thanks for the help,it's always appreciated.