Factory Five Racing Forum banner

Dash Corner Mod

957 views 3 replies 4 participants last post by  hotrod bill 
#1 ·
I've searched and cannot find info on cutting the dash corners. Could anyone point me in the right direction?

Thanks
Eric
 
#4 ·
Eric,
I cut a 3" x 3" triangle out of my bottom corners and it works OK, but if I had to do it over I would cut a 3" high x 5" horizontal piece out.
Hope this helps, Bill

P.S. one of the smartest things I did to the dash was to make the dash top piece separate and removable.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top