For Sale: Prototype roll bars

[convincor]

Breeze prototypes, been hanging around shop..
Three drivers side and a passenger. I'd like to see the driver/passenger stay as a pair.
All are assemble on my fixture which has been used to assemble 5 or six bars for local guys and the bars fit there cars ranging from MK1-MK4..
Are they going to be absolutly perfect fit for you?? I don't know. Especially the passenger side. But if your passenger rear leg mount is bolt in there should be no reason you cant get it to work.
Two drivers have the long rear leg so no visible seam above the body.
One I did with the seam as FFR does there's.
These have the bends at the same height so the inner hole will be off center by about a 1/4". If your body isn't finished or your holes aren't cut you'd be all set.. #2 has the bends at different heights and fitts stock holes. I will also suppy the stubs for install..
$50 each plus shipping
pick by #..
#1 with seam



#2 SOLD[IMG]http://i101.photobucket.com/albums/m41/convincor/roll%20bar/photobucket-38341-1349347600080.jpg[/IMG]


#3 the pair driver/pass

[Carl Johnson]

And they just look GOOD!

[SeanHM]

Oh that is tempting....

[quicksand]

i could use a bolt in stub for the down tube...just saying

[CapeCoralCobra]

I'll take this one if it's still available: #2 has the bends at different heights and fitts stock holes.

Sending PM

[convincor]

# 2 is SOLD

[SeanHM]

Dibs on the #3 pair. PM sent. Can't wait. I've been fitting a pair of Corbeaus and noticed that my current bar is ridiculously high with those seats. Like 5"- 6". These will be perfect. Thanks.

[GW6929]

are these the same dia tubes as FFR uses & also roughly the same height?

I ask because I'd prefer a smaller diameter & shorter bar in my mk1

thanks

Jim

[Carl Johnson]

GW6929,
The bar is 1 3/4 dia. a bit smaller than your 2 in FFR bar, and it is a bit shorter.
HTH
Carl

[GW6929]

I'd like #1 if it's still avail

PM sent

Jim

[GW6929]

Carl Johnson

nice looking car! thanks for the help

Jim

[CapeCoralCobra]

Carl or Scott, I currently have the FFR rollbar grommets. Is there a source for premade rubber sealing grommets (under the aluminum grommets) to fit this rollbar?

Thanks

[convincor]

ALL SOLD!!
Thanks guys.
As for the rubber, McMaster Carr. Id say maybe 8610K82 would be a good choice. McMaster-Carr

[CapeCoralCobra]

Just wanted to bring this back to thank Convincor again for putting up such great deals on his prototypes and show a finished product. I had to adjust the roll bar legs just a bit with a couple long pry bars and a ratchet strap, as the straight tube was already welded on, but it was worth the effort. Filled the grind marks, painted it the same Pure White as the stripes, made new rubber grommets, & done. I've always thought the Mk 3.1 & earlier rollbars are a little large, diameter and height, so I'm really pleased with the results, about 2" shorter than the FFR bar.

[convincor]

A pic from your graduation thread for comparison...
The new one looks much better IMO. Nice job.