I enjoyed our conversation earlier today. It's been a long time since someone has called me a liar. To answer your question you could just do as you stated in this post.
[QUOTE=Racer 28;2520954]Yes, if you have a mis-aligned set of louvers, I will send you a new set.
__________________
Mark III complete kit ordered 12/03/2007, received #6351 1/22/2008 Homemade mods: driver footbox extension with deadpedal and dimmer switch, widened passenger footbox, brake reservoir mounting bracket, under trunk storage box, custom dash and dash extension, heater forward box, custom glove box, under dash switch panel, Explorer motor carb conversion, first start 7/10/2010, paint by Performance Automotive 11/20/2010-5/7/2011, Graduated 11/22/2011
Last edited by Silverstreak02; 05-16-2012 at 02:13 AM..
Reason: spelling
They say a picture is worth a thousand words.. So here ya go.
Jeff you do know that can adjust the angle of these beautiful louvers.
Both of these cobras where finished at Metal-Morphous Inc and the stainless steel louvers were supplied by Joey. They bodies are both MK4s but the difference is that the red cobra has the Joey's early design SS louver and the black cobra has his new design. As you can see with a little tweaking you can get both styles to fit perfect.
Jeff the paint on your cobra looks fantastic, is that "Show Finish" I know that can be very expensive, somewhere in the 15K bracket, if so how do you protect it from sand and stone damage when you drive it to shows, or do you trailer it?
Joey, Joey, Joey......12 or 20. Personaly I recomend the 20. Gets the job done without a lot of extra flash and cleanup. BTW I can only get the 4010 clear....you said yours was 4000. Is that correct?
__________________
Drink me handsome and take me home....Bartender, I'd like to buy the little lady a drink...better make it a double.
Thanks Wayne,,, Here's a photo of another one I think you might like. Just finished this one this week. As you can see these are the aluminum louvers and do not shine. I have seen them polished but it a real pain and they will not stay shiny for long and clear coating them is not an option. If you want a high shine, low maintenance louver Joey's louvers are the way to go..
Welcome to FFCars! The
representations expressed are the representations and opinions of
the FFCars.com forum members and do not necessarily reflect the
opinions and viewpoints of the site owners, moderators, Factory Five
Racing, Inc. or Ford Motor Company. This website
has been planned and developed by FFCars.com and its forum members
and should not be construed as being endorsed by Factory Five
Racing, Inc. or Ford Motor Company for any
purpose. "FFR", "Factory Five", "Factory Five Racing", and the
Factory Five Racing logo are registered trademarks of Factory Five
Racing, Inc. FFCars.com forum members agree not to
post any copyrighted material unless the copyrighted material is
owned by you. Although we do not and cannot review the messages
posted and are not responsible for the content of any of these
messages, we reserve the right to delete any message for any reason
whatsoever. You remain solely responsible for the content of your
messages, and you agree to indemnify and hold us harmless with
respect to any claim based upon transmission of your message(s).
Thank you for visiting the FFCars.com Forum dedicated to Factory
Five.
Joey, Joey, Joey......12 or 20. Personaly I recomend the 20. Gets the job done without a lot of extra flash and cleanup. BTW I can only get the 4010 clear....you said yours was 4000. Is that correct?
Xterminator
Linear Mode
